No data in SDR and NDR

Science, Research & Data
1

Hello everyone.
I ran the NDR model and the SDR, and I was very careful. But in the output of the models it shows no data in maps. I also checked the DEM map. But I did not find the answer.

Thanks

image
image1789×901 169 KB

2

Hi @h.kazmi -

Do those NoData areas correspond to missing data in any of your model inputs? Check out the Defined Area of Outputs section of the User Guide and let us know if anything in there helps.

~ Stacie

1 Like
3

Hi swolny,

I checked the input data. None of them had no data problem. I also changed the TFA, KB, and LS values ​​and ran the model again. But the problem was still there. I also checked the biophysical table data, but to no avail.

I have already run the water yield model. That model had no problem. However, in the NDR and SDR models, this problem persists - the primary difference between these two models and the water yield model is the inclusion of the Digital Elevation Model (DEM). I think the problem may be with this map. Of course, I am not sure.

Thanks

4

Hi,

Thanks for your help.
I forgot to mention, I’m using version 3.14.3 of Invest.